Aluminum, CPE Wing Assembly for 1/18 Hasbro Hero X-Wing Conversion

$175.00

This set of wings is an accurate representation of the Studio Scale X-Wing wings scaled up to 1/18 scale. The wing assembly consists of 6065 laser cut 1.5mm thick aluminum wing sides, FDM printed middle section, and “connector” part. Please note, this listing does not include SLA plant-on parts.

The package will include parts for 4 wings:

12 FDM parts – 3 parts for each wing

8 aluminum parts – 2 parts for each wing

FDM parts connect and are glued between the aluminum sections.

Aluminum, CPE Wing Assembly for 1/18 Hasbro Hero X-Wing Conversion

This is an example of the assembled wing with the engine and laser cannon parts attached. Please note the engine and laser cannon parts are available separately

Aluminum, CPE Wing Assembly for 1/18 Hasbro Hero X-Wing Conversion

A few notes:

CPE parts are printed in an FDM printer and do not have the surface finish as good as the SLA printed parts. To improve the surface finish the parts might need to be sanded or skinned with thin styrene sheets

The aluminum parts have the score lines etched on the surface. The etching may not go as deep as desired. If you like to make it deeper you will need to scribe the lines with a sharp tool using score lines as a guide.

We suggest using an adhesion promoter for gluing the CPE and aluminum parts together.

We Also Recommend

Sold Out

X-Wing Light Controller Version 2 for 1/29, 1/24 Studio Scale and 1/18 X-Wing, Y-Wing

Pilot Variant A for 1/18, 1/29, 1/24 Studio Scale X-Wing and Studio Scale Y-Wing

Sold Out

Discontinued. X-Wing Light Controller for 1/29 Scale, 1/24 Studio Scale and 1/18 Scale X-Wing

Power Supply for the X-Wing Light Controller for 1/29 Scale, 1/24 Studio Scale and 1/18 Scale X-Wing

Pilot Variant B for 1/18, 1/29, 1/24 Studio Scale X-Wing and Studio Scale Y-Wing